Release date
Tuesday, May 29, 2018
Symptoms
Automation Engine tasks (f.i. the "Check Job Parameters" task) did not support the MFOLD screen properly even after its rename from MF to MFOLD.
The tasks will revert (without warning or error) to the default screen.
Curve Pilot: Dot MFOLD was not in the default list of dotshapes. It could be added manually, but that had to be redone every single time.
System requirements
The standard system requirements for this product apply. You can verify them on www.esko.com/en/systemrequirements.
Dependencies
This hotfix has no known dependencies on other hotfixes or patches.
Installation Instructions
Stop the master Automation Engine 16.1.1 Server (and assistants/standins if any). Install this hotfix on the server(s) and restart (them).
Downloads
Disclaimer
DISCLAIMER OF WARRANTIES: ESKO GRAPHICS BV (HEREINAFTER REFERRED TO AS "ESKO") DOES NOT GUARANTEE THAT YOU WILL BE ABLE TO SUCCESSFULLY DOWNLOAD OR IMPLEMENT ANY HOTFIX, PATCH OR SERVICE PACK, OR ANY OF THE TIPS, SAMPLES OR SUGGESTIONS DESCRIBED IN ANY ESKO PRODUCT SUPPORT DOCUMENTATION, INCLUDING KNOWLEDGE BASE ARTICLES. ALL ESKO TECHNICAL DOCUMENTS, HOTFIXES, PATCHES AND SERVICE PACKS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
LIMIT OF LIABILITY: BY DOWNLOADING OR IMPLEMENTING THE HOTFIXES, PATCHES AND SERVICE PACKS YOU AGREE THAT ESKO HAS MADE NO EXPRESS WARRANTIES TO YOU REGARDING SAID ITEMS, AND THAT SAID ITEMS ARE PROVIDED TO YOU 'AS IS' WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL ESKO OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL LOSS OF DATA, OR LOST BUSINESS PROFITS OR SPECIAL DAMAGES, THAT MAY OCCUR AS A RESULT OF IMPLEMENTING A HOTFIX, PATCH OR SERVICE PACK OR WORKAROUND, OR ANY SUGGESTION OUTLINED IN ANY ESKO PRODUCT SUPPORT TECHNICAL DOCUMENT, EVEN IF ESKO OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.